Telefon: +386 (0)59 108 495
Naročila nad 100€ Brezplačna dostava
Close
Kremplova ulica 2, 2000, Maribor
+386 (0)59 108 495 info@lovskaoprema.si
Odpiralni čas: Pon - Pet 8.00 - 16.00

.337″ Heat-Treated Steel Neck Sizing Bushing

31,61

.337″ Heat-Treated Steel Neck Sizing Bushing

19 na zalogi

Šifra: RT-RED-73337 Kategorije: , , , Številka produkta: 36675

Opis

Heat treated steel. The sizing diameters are hand-polished with a surface hardness of Rc 60-62 to reduce sizing effort .

Redding Neck Sizing Bushings are available in two styles. Both share the same external dimensions (1/2″ O.D. x 3/8″ long) and freely interchange in all Redding Bushing Style Sizing Dies. They are available in .001″ size increments throughout the range of .185″ thru .368″, covering all calibers from .17 to .338 and clearly marked with size I.D. By selecting the correct bushing, you are now able to provide just the right amount of neck tension to properly hold the bullet without excessive resizing.

Bushing Selection and Use

The easiest way to determine the proper diameter bushing, is to measure the neck diameter of several loaded or dummy cartridges with an accurate micrometer. Subtract .001”–.002” from the average neck diameter and this diameter bushing will generally size case necks to create the proper press fit for the bullet.

Another method is to measure the neck thickness with a ball micrometer or our Case Neck Gauge (see page 33). Double the neck wall thickness and add this number to the bullet diameter. The result is the neck diameter of a loaded cartridge, and bushing size can be determined as above.

After loading several cases, it’s a good idea to test the neck’s grip on the bullet. The simplest method is to push the bullet in a loaded cartridge against the edge of your reloading bench with moderate hand pressure. The bullet should not move easily in the case neck. If the bullet pushes deeper in the case, select the next smaller bushing and start again.

When using your bushing die, we have found that lubricating case necks and installing the bushing numbers down may improve results. Many experienced reloaders like to adjust the die to size 1/2 to 3/4 of the case neck. This has been shown to improve accuracy in most instances.

Final note: If you are not sorting case neck wall thickness for uniformity, we do not recommend the use of any bushing style die without a sizing button.

Dodatne informacije

Teža 0.06 kg