Telefon: +386 (0)59 108 495
Naročila nad 100€ Brezplačna dostava
Close
Kremplova ulica 2, 2000, Maribor
+386 (0)59 108 495 info@lovskaoprema.si
Odpiralni čas: Pon - Pet 8.00 - 16.00

308 Winchester Type S-Match Full Die Set

337,72

308 Winchester Type S-Match Full Die Set

4 na zalogi

Šifra: RT-RED-36155 Kategorije: , , , , , , Številka produkta: 36699

Opis

TYPE S – MATCH Bushing Full Die Set

CONTAINS

•Type S – Bushing Full Sizing Die

•Body Die

•Competition Seating Die

!SIZING DIE REQUIRES CORRECT BUSHING, WHICH IS NOT INCLUDED!

Competition Bullet Seating Die

“No seating die on the market is built to this level of precision.”

This patented design quickly established itself as the “state of the art” in straight line bullet seaters and beat the concentricity problems inherent in all other seating dies of this type. Tighter manufacturing tolerances were made possible due to the details of the floating seating stem system. The bullet guide to seating stem fit is so precise that the seating stem can actually be demonstrated to “float” on a column of air. The seating stem is precision ground to exactly match the bullet diameter.

Alignment and accuracy are enhanced by the cartridge case and bullet being completely supported and aligned in a close fitting, precision ground sleeve before the bullet seating begins. The micrometer is calibrated in .001″ increments for precise seating depth and is infinitely adjustable. The micrometer also has a feature that allows you to re-set it to your favorite seating depth. No seating die on the market is built to this level of precision.

Bushing Selection and Use

The easiest way to determine the proper diameter bushing, is to measure the neck diameter of several loaded or dummy cartridges with an accurate micrometer. Subtract .001”–.002” from the average neck diameter and this diameter bushing will generally size case necks to create the proper press fit for the bullet.

Another method is to measure the neck thickness with a ball micrometer or our Case Neck Gauge (see page 33). Double the neck wall thickness and add this number to the bullet diameter. The result is the neck diameter of a loaded cartridge, and bushing size can be determined as above.

After loading several cases, it’s a good idea to test the neck’s grip on the bullet. The simplest method is to push the bullet in a loaded cartridge against the edge of your reloading bench with moderate hand pressure. The bullet should not move easily in the case neck. If the bullet pushes deeper in the case, select the next smaller bushing and start again.

When using your bushing die, we have found that lubricating case necks and installing the bushing numbers down may improve results. Many experienced reloaders like to adjust the die to size 1/2 to 3/4 of the case neck. This has been shown to improve accuracy in most instances.

Final note: If you are not sorting case neck wall thickness for uniformity, we do not recommend the use of any bushing style die without a sizing button.

Dodatne informacije

Teža 0.91 kg